DSpace
 

EMU I-REP >
02 Faculty of Engineering >
Department of Mechanical Engineering >
Theses (Master's and Ph.D) – Mechanical Engineering >

Please use this identifier to cite or link to this item: http://hdl.handle.net/11129/3877

Title: Experimental Study on a Solar Air Heater with Various Perforated Covers and Bed Heights
Authors: Egelioğlu, Fuat (Co-Supervisor)
Aldabbagh, Loay (Supervisor)
Nowzari, Raheleh
Eastern Mediterranean University, Faculty of Engineering, Dept. of Mechanical Engineering
Keywords: Mechanical Engineering
Solar Energy
Heating
Air Heater
Solar air heater
perforated cover
packed bed
thermal efficiency
Issue Date: Sep-2014
Publisher: Eastern Mediterranean University (EMU) - Doğu Akdeniz Üniversitesi (DAÜ)
Citation: Nowzari, Raheleh. (2014). Experimental Study on a Solar Air Heater with Various Perforated Covers and Bed Heights. Thesis (Ph.D.), Eastern Mediterranean University, Institute of Graduate Studies and Research, Dept. of Mechanical Engineering, Famagusta: North Cyprus.
Abstract: In this study, the thermal performance of the single and double pass solar air heaters with normal glass cover, Plexiglas cover, quarter and half perforated covers were investigated experimentally. In this system, the conventional absorber plate was replaced with fourteen steel wire mesh layers. The solar air collector was tested with four different perforated covers. On two perforated covers the holes were made on the first quarter at the top side of the cover in an area of 100 × 36 cm2 . On the other two covers, half of the cover area (i.e. 100 × 72 cm2 ) on the top side was perforated. The holes made on one of the quarter and one of the half perforated covers had the center-to-center distance (dc) of 20D (6cm) and on the other two covers dc was 10D (3cm). D was the hole diameter that is fixed to be 0.3cm. The air mass flow rate was varied between 0.011 kg/s and 0.037 kg/s. The solar collector was also tested with three different bed heights (3, 5.5 and 8cm) in order to examine the effect of duct height on the efficiency of the air heater. The height of upper channel was 2cm in double pass collector. In this research the effects of different mass flow rates, various perforated covers and different bed heights on the outlet temperature and thermal efficiency were studied. The obtained results show that as the mass flow rate increases, the thermal efficiency also increases but the temperature difference between the outlet and inlet air, ΔT, decreases. The efficiency of the double pass collector with glass cover was always greater than the single pass collector with the same cover by 5 - 22.7% for the same air mass flow rates. In case of solar air heater with the quarter perforated cover, it was found that, the efficiency of the air heater with the 10D quarter perforated cover is slightly higher than the one with 20D quarter perforated cover for both single and counter flow collectors and that is because the 10D cover was cooler than 20D cover during the tests and this reduces the heat lost from 10D cover to the ambient. It was found that the solar air heater with quarter perforated cover reaches to higher ΔT than with the half perforated or normal Plexiglas cover. At mass flow rate (ṁ) of 0.032 kg/s, the maximum efficiency of the double pass solar collector with quarter perforated covers 20D and 10D were, 57.60% at 13:00h and 60.49% at 15:00h, respectively while at the same ṁ, for the same collector with half perforated covers 20D and 10D the maximum value of efficiency obtained were 52.66% at 12:00h and 57.93% at 15:00h, respectively. The results show that the thermal efficiency of the solar air heater decreases by increasing the bed height of the collector. The collector with duct height of 3cm was shown higher performance compared with the one with bed height of 5.5 or 8 cm. Keywords: Solar air heater, perforated cover, packed bed, thermal efficiency
Öz: Bu çalışmada, normal cam örtülü, pleksiglas örtülü, çeyrek ve yarı delikli örtülü tek ve çift geçişli güneş hava ısıtıcılarının ısıl performansı deneysel olarak incelenmiştir. Bu sistemde, geleneksel emici levha, on dört çelik tel örgü tabaka ile değiştirildi. Güneş hava kolektörü dört farklı delikli örtü kullanılarak test edildi. İki örtüde delikler örtünün üst çeyreğindeki 100 × 36 cm2 lik alana açılmıştır. Diğer iki örtüde, örtü alanını üst yarısı (100 × 72 cm2 ) delinmiştir. Çeyrek ve yarı alanı delinen iki örtünün deliklerinin merkezden-merkeze uzaklıkları (dc) 20D (6 cm) diğer iki örtünün deliklerinin merkezden-merkeze uzaklıkları ise 10D (3 cm) dir. D delik çapı olup 0.3 cm olarak sabitlendi. Hava debisi 0.011 kg/s ve 0,037 kg/s arasında değiştirilmiştir. Güneş kolektörü, kanal yüksekliğinin hava ısıtıcısının verimliliğine etkisini incelemek amacıyla üç farklı kanal yüksekliğinde (3, 5.5 ve 8 cm) test edilmiştir. Üst kanal yüksekliği çift geçişli kolektörde 2 cm dir. Bu araştırmada farklı kütle akış hızlarının, çeşitli delikli örtülerin ve kanal yüksekliklerinin çıkış sıcaklığına ve ısıl verimliliğine olan etkileri çalışılmıştır. Elde edilen sonuçlara göre kütle akış hızı arttıkça ısıl verimlilik artar, ancak çıkış ve giriş havası arasındaki sıcaklık farkı, ΔT, azalır. Aynı hava kütle akış hızı için cam örtülü çift geçişli kolektörün verimliliği, aynı örtülü tek geçişli kolektörün verimliliğinden % -22.7 daha büyüktür. Çeyrek delikli örtülerde,10D çeyrek delikli örtülü hava ısıtıcısının verimliliği tek ve çift geçişlerde 20D çeyrek delikli ötülü hava ısıtıcısının verimliliğinden daha yüksek bulunmuştur, bunun nedeni, yapılan testlerde 10D çeyrek delikli örtünün 20D çeyrek delikli örtüye göre sıcaklığının daha düşük olmasından dolayı çevreye olan ısı kaybını azaltmasına bağlanmaktadır. Çeyrek delikli örtülü güneş hava ısıtıcısının, yarı delikli veya normal pleksiglas örtülü hava ısıtıcılarına göre daha yüksek ΔT ye ulaştığı tespit edilmiştir. Kütle akış hızı (𝑚����̇) 0.032 kg/s olduğunda, 20D ve 10D çeyrek delikli örtülü hava ısıtıcısında maksimum verimlilik saat 13:00 ve 15:00 da sırasiyle %57.60 ve %60.49 dur; Aynı kolektör için 20D ve 10D yarı delikli örtü kullanıldığında hava ısıtıcısındaki maksimum verimlilik saat 12:00 ve 15:00 da sırasıyla %52.66 ve %57.93 tür. Sonuçlar, güneş hava ısıtıcısının ısıl verimliliğiin kolektör kanal yüksekliğini artması durumunda azaldığını göstermektedir. (Kanal yüksekliği 3 cm olduğunda elde edilen ısıl verimlilik 5,5 veya 8 cm kanal yüksekliği kullanıldığında elde edilen ısıl verimliliklerden daha yüksektir). Anahtar kelimeler: Güneş hava ısıtıcısı, delikli örtü, gözenekli yatak, ısıl verimlilik
Description: Doctor of Philosophy in Mechanical Engineering. Thesis (Ph.D.)--Eastern Mediterranean University, Faculty of Engineering, Dept. of Mechanical Engineering, 2014. Supervisor: Assoc. Prof. Dr. Loay Aldabbagh, Co-Supervisor: Prof. Dr. Fuat Egelioğlu.
URI: http://hdl.handle.net/11129/3877
Appears in Collections:Theses (Master's and Ph.D) – Mechanical Engineering

Files in This Item:

File Description SizeFormat
NowzariRaheleh.pdfThesis, Doctoral2.57 MBAdobe PDFView/Open


This item is protected by original copyright

Recommend this item
View Statistics

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.

 

Valid XHTML 1.0! DSpace Software Copyright © 2002-2010  Duraspace - Feedback